User`s guide

Using the SLTA-10 Adapter with a

Modem

This chapter describes the operation of the SLTA-10 Adapter when a

remote host computer is connected via a pair of modems to the

SLTA-10 Adapter. In this set-up, any node on the network may

request the SLTA-10 Adapter to initiate a dial-out operation to connect

to the host. In addition, if the SLTA-10 Adapter is functioning in NSI

mode, the SLTA-10 Adapter itself may be configured to initiate a dial-

out operation to connect to the host. The SLTA-10 Adapter can store a

telephone directory of commonly called numbers, as well as accept

commands to dial any other number.

The SLTA-10 Adapter may also be configured to accept incoming calls

and connect the network to the host. Incoming callers may optionally

be required to provide a password before the SLTA-10 Adapter will

connect them to the network.

See Chapter 7, Using the Windows 95198 and NT Drivers and

SLTALink Manager with SLTA-10 NSI Mode, for configuring the

SLTA-10 NSI mode EEPROM through the SLTALink Manager

application.

SLTA-10 Adapter User’s Guide

1 l-l