User`s guide

Network Management Messages
Network management messages are used to configure the operation of the network,
as opposed to delivering application data during operation of the network. All
LONWORKS nodes respond to the standard network management messages as
described in Appendix B of the Neuron Chip Data Book.
For nodes based on the
SLTA-10 Adapter, additional network management messages are defined to
configure and control the SLTA-10 Adapter. The message codes for network
management messages are reserved, and therefore applications need not be
concerned about possible conflicts in the choice of message codes. The additional
SLTA-10 Adapter network management messages use the reserved message code 7D
hex. The first data byte is used as a sub-code, and is 01 hex to indicate an SLTA-10
Adapter function. The second data byte is a specific application command code.
Table 11.1 summarizes the network management messages specific to the SLTA-10
Adapter.
SLTA-10 Adapter User’s Guide
11-5