User`s guide

11-6
Table 11 .l
SLTA-10 Adapter Network Management Messages
These network management messages may be sent from any node on the network to
the SLTA-10 Adapter. If an application node wishes to send modem-control network
management messages to the SLTA-10 Adapter, it does so using explicit messaging.
See Chapter 4 of the Neuron C Programmer’s Guide for details on explicit messaging.
The message should be delivered using request/response service, and the message code
for modem control messages is always 7D hex. The data portion of the message always
begins with a sub-code value of 1, indicating that the message is addressed to an
SLTA-10 Adapter, followed by an application command byte indicating which modem-
control command this is. This is followed by parameters specific to the application
command. These messages may be sent by a Neuron C-based node, a node based on
the Microprocessor Interface Program (MIP), or a node based on another SLTA-10
Adapter.
Using the SLTA-10 Adapter with a Modem