User`s guide

12-6
Using the DOS Host Connect Utility with SLTA-10 MIP Mode
Table 12.1 HCU Progress Strings
deuname: No such file or
Indicates that HCU could not open the device deuname.
directory or Not ready reading
device devname
Dialing or Hanging up
Indicates the HCU operation.
Device initialization error,
Indicates a problem with initializing the network driver.
devname
Could not open file filename
Indicates a problem with opening the string argument file.
Password Format error, abort Indicates there was a problem interpreting the password
argument.
Modem Response Timeout
Indicates that the modem did not respond to a command
string.
DCD state test error, deuname
Indicates a problem communicating with the network
driver.
Connect timeout, devname
Indicates that the connection was not established within the
connection timeout period.
User Abort
Indicates that the connect wait process was aborted by the
user.
Connected
or Connection Failed
Indicates the status of the connection. If the message
Connect ion Failed appears following what appears to be
a successful modem connection there may be a problem with
the DCD signal from the modem.
Downlink Password Failure
Indicates a problem sending the password command
downlink to the SLTA-10 Adapter. The connection may
have been broken unexpectedly.
Password Validation Fail Indicates that the remote SLTA-10 Adapter has responded
to the password command with a negative acknowledgment.
You are probably using the wrong password.
Password Validation Complete Indicates a successful password command transfer with the
remote SLTA-10 Adapter, and that HCU has successfully
communicated with the remote SLTA-10 Adapter.
Downlink Password Timeout Indicates no password acknowledgment or negative
acknowledgment was received. Either the remote SLTA-10
Adapter is not operational, or the SLTA-10 Adapter link
layer protocol does not match, or there is a problem with
transferring binary data across the modem connection.
Hangup Failed, Still
Connected
Indicates HCU still thinks that the connection is made
following a hangup. This could be the result of a persistent
DCD ON level.