User`s guide

5. When prompted for a program name, enter the following:
A:\SETUP.EXE
If necessary, replace A : with the drive letter which corresponds to the
drive containing the SLTA-10 NSI mode installation diskette.
6.
7.
When prompted click the button marked ‘Next >“.
When prompted for a destination directory, enter the desired
installation directory. By default this directory is c : \ 1 onwor ks,
unless previous LONWORKS products have been installed and have
registered a different path in the Windows Registry. The path may
be modified using the “Browse” button.
8. The next screen presented is shown in figure 5.1. This will determine
the LONWORKS naming convention used for the SLTA-10 adapter.
Figure 5.1 LONWORKS Device Naming Convention
9. Clicking the “Next” button concludes installation. At the prompt to
restart the computer, remove the SLTA-10 NSI mode installation
diskette and restart the computer. Note that the Windows
operating system will not recognize the SLTA-10 adapter until
the computer is restarted.
SLTA-10 Adapter User’s Guide
5-3