User`s guide

!
Causes a carriage return to be sent.
Causes a 500ms pause.
The carriage return is not required at the end of the string.
Clear EE Pool on Apply
Check this box to clear the SLTA’s EEPROM pool before applying the configuration.
This will force the clearing and re-programming of the strings that use the EEPROM
pool: The Modem Initialization and Dial Prefer strings, and the Dial Directories. If
not checked then only the SLTA’s strings that have been changed will be updated.
Use this feature if you are increasing the size of one string and decreasing the size of
another in one step.
Dial Directories
Provides a space to enter the dialout directory numbers, as strings. To chose which
directory entry to edit, simply select one of the buttons above.
! Causes a carriage return to be sent.
Causes a 500ms pause.
The carriage return is not required at the end of the string.
Auto-da/out Configuration
NV Connect
Check this box to enable the Network Variable update auto-connect feature. When
enabled, the SLTA will attempt to connect to a remote host whenever the SLTA is
not connected and a non-broadcast host-bound NV update message is pending.
The SLTA starts with the directory number first specified on the right. If this
attempt fails then the next directory number is used, until the last directory number
has been used. To use a single number simply specify the same directory number in
both fields.
N$I Connect
Check this box to enable the Network Services (NSI) auto-connect feature. When
enabled, the SLTA will attempt to connect to a remote host whenever the SLTA is
not connected and a host-bound NSI message is pending.
The SLTA starts with the directory number first specified on the right. If this
attempt fails then the next directory number is used, until the last directory number
has been used. To use a single number simply specify the same directory number in
both fields.
I
7-12
SLTA-10 NSI Mode Software