User`s guide

Using the DOS Driver with

SLTA-10 MIP Mode

This chapter describes the DOS network driver supplied with the

Connectivity Starter. The driver also is available from the Developer’s

Toolbox on Echelon’s web site at www.echelon.com. The DOS network

driver provides a device-independent interface between a DOS or

Windows 3.1x host application and the SLTA-10 Adapter in MIP mode.

The driver is configurable to use one of four PC/AT serial ports, COMl

through COM4, at one of eight serial bit rates.

Skip this chapter if you are using the SLTA-10 NSI mode.

SLTA-10 Adapter User’s Guide

8-l