User`s guide

Sub-command 2 is used to set the state of the DTR line.
In this case, the DTR signal
is enabled (on) if the mode field is true.
Sub-command 3 is used to set the serial bit rate of the serial interface. The mode
field determines the new bit rate as follows: 0:14,400; 1:1,200; 2:2,400; 3:9,600;
4:19,200; 538,400; 657,600; 7:115,200.
Using the SLTA- 10 MIP Mode under Microsoft Windows 3.1 x
In order to use the SLTA-10 MIP mode network driver for DOS under Microsoft
Windows 3.1x, an interface based on the DOS Protected Mode Interface (DPMI) must
be provided. This type of interface, in the form of Windows DLL software, is supplied
with the Connectivity Starter Kit, as well as with the LonManager API for Windows
and LonManager DDE Server. The interface software is called WLDV.DLL. See
Appendix A for information on using the Windows 3. lx DLL directly.
8-10
Using the DOS Driver with SLTA-10 MIP Mode