Owner`s manual

Console Software
36
Console Software
Clock Source
Under clock source you may select the input clock source. The clock source
setting is used to synchronize your AudioFire hardware to another piece of audio
hardware. If a given synchronization source (input clock) is not detected, that clock
source will be grayed out. You will only be allowed to select input clocks that are
currently connected. For more information please refer to “Synchronizing
Multiple Devices” later in this manual.
If an external clock is selected and that clock is disconnected, the button will turn
red. You will either need to reconnect the clock source or select the internal clock
button.
Digital Mode (and AudioFire Pre8)
There are three different digital modes: S/PDIF coax, S/PDIF optical and ADAT
optical. Click on the mode that best suits your needs. For instance, if you want to
sync to ADAT, you will need to click on the ADAT optical button.
Note: At 44.1K and 48K there are 8 channels of ADAT available. At 88.2K and
96K there are only 4 channels of ADAT available.
About Dialogue Box
Version Information
Version information for all the components of your AudioFire system is displayed
in the About Dialogue Box which can be found on the Settings Tab. Simply click
on the About button. Note that when the About Dialogue Box is open, you are
frozen out of the console until you close this box.