Owner manual

8 INCH PTO CHIPPERS

1. Three point hitch connection: Mounts chipper to

tractor 3 pt. hitch.

2. PTO shaft: Connects chipper to tractor PTO shaft.

Avoid driveline angles over 20 degrees on PTO shaft

when unit is in use. NOTE: Minimum and maximum

telescoping on the PTO shaft is 20.08" to 26.93". This

will leave a 6.85" overlap.

3. Drive belt shield: Never remove shield while machine

is running.

4. Chipper chute: Feeds materials to the chipper blades

for chipping.

3.1 CONTROLS

Figure 3.1.1, Chipper controls

CONTROLS & OPERATION

Section

5. Leg stands: Never move machine unless the 3 point

is lifted and legs clear the ground.

6. Rotor access cover: Tilts up to remove chipper blades

and to service rotor assembly.

7. Discharge tube: Chipped materials will exit through

this tube. It is adjustable 360 degrees. The discharge

tube for the 76854 model is not adjustable. It is de-

signed to blow materials onto the ground.

8. Adjustable chipping anvil: Adjusts to change the size

of the chips.

9. Rotor shaft bearing cover: Covers rotor shaft and

front bearing.