Owners Manual v.3 User guide

4 INCH CHIPPER
13
ENGLISH
OPERATION
4.5 OPERATING THE CHIPPER
CAUTION
WARNING
NOTE

   
that the rotor has stopped when no noise or machine
vibration is present. Inserting a branch into the chipper
chute to contact the blades will slow the rotor and
shorten stopping time.
WARNING
WARNING

Failure to operate the machine in accordance with
MAY RESULT IN PERSONAL
INJURY!
        
operating the machine.


pants and a long-sleeved shirt.
       


Never        

paddle.
Never



Never
Never 
the chute.
         


1. Run unit at full operating speed
chip material.
2. Limbs fed in to the chipper chute must be 4 inches
(10 cm) in diameter or less. Trim side branches that

Hold small diameter branches together in a bundle and

3. Exclude pieces of metal, rocks, bottles, cans, and
other foreign objects
machine.
4. Feed brush from the side of the chipper chute,


5. Place limb, butt end first, into the chipper chute
until it contacts the chipper blades.


6. If the engine slows to where it may stall, stop


7. If the chipper jams, remove the branch and rotate it


will not kill the engine.
8. Do not use the clutch to clear a plugged rotor.

        
Maintenance section.
9. Alternate greener material with dry material to



10. Sharpen the chipping blades periodically. Check


instructions.
       
 


