Owners Manual v.3 User Manual

4 INCH CHIPPER
12
SAFETY
Safety and instruction decals are located on the chipper frame and engine. Replace any decal that is damaged or unreadable.
1.11 SAFETY DECALS
1
PN 12010
PN 12169
3
KEEP HANDS AND FEET
OUT OF INLET AND
DISCHARGE OPENINGS WHILE
MACHINE IS OPERATING TO
AVOID SERIOUS PERSONAL
INJURY. ALLOW MACHINE TO
COME TO A COMPLETE STOP
BEFORE CLEARING OBSTRUC-
TIONS.
PN 12172
4
READ AND UNDERSTAND THIS
OWNER/OPERATORS MANUAL.
BE COMPLETELY FAMILIAR WITH
THE CONTROLS AND THE PROP-
ER USE OF THIS EQUIPMENT.
OBTAIN AND WEAR SAFETY
GLASSES AND USE HEARING
PROTECTION AT ALL TIMES
WHEN OPERATING THIS MA
-
CHINE.
BEFORE INSPECTING OR SER
-
VICING ANY PART OF THIS
MACHINE, SHUT OFF POWER
SOURCE, DISCONNECT SPARK
PLUG WIRE FROM SPARK PLUG
AND MAKE SURE ALL MOVING
PARTS HAVE COME TO A COM-
PLETE STOP.
PN 12173
5
DO NOT OPERATE THIS EQUIP-
MENT IN THE VICINITY OF BY-
STANDERS. DO NOT ALLOW
CHILDREN TO OPERATE THIS
EQUIPMENT. ALWAYS STAND
CLEAR OF DISCHARGE AREA
WHEN OPERATING THIS MA-
CHINE. KEEP FACE AND BODY
AWAY FROM DISCHARGE AREAS.
PN 12174
6
DO NOT OPERATE MACHINE
WITHOUT SHIELDS IN PLACE.
FAILURE TO DO SO MAY CAUSE
SERIOUS INJURY OR DEATH.
PN 12175
7
KEEP HANDS AND FEET OUT
OF INLET AND DISCHARGE
OPENINGS WHILE MACHINE IS
OPERATING TO AVOID SERI-
OUS PERSONAL INJURY. AL-
LOW MACHINE TO COME TO
A COMPLETE STOP BEFORE
CLEARING OBSTRUCTIONS.
PN 12183
8
PRESS CLUTCH PEDAL
DOWN WITH FOOT TO
DISENGAGE BELT WHILE
STARTING ENGINE. SLOWLY
RELEASE FOOT TO ENGAGE
CHIPPER BELT AFTER CHIP-
PER IS RUNNING.
PN 12168
2
KEEP HANDS, FEET AND BODY
AWAY FROM DRIVESHAFT
WHILE MACHINE IS OPERAT
-
ING TO AVOID ENTANGLE-
MENT. OPERATE MACHINE AT
540 RPM.