Installation Instructions

1
KIT CONTENTS:
Large Purge Bulb (P005003120)
Replaces:
Shindaiwa 12538108660, P005003110,
12538146730
ECHO 12538108660, P005003110,
12538146730
Stihl 4226 121 2700
Zama 0057003, 0057004, 0057034,
0057035
Stens 615-792
Fits: Zama C1M, C1Q and C1U Zama carburetors
Small Purge Bulb (12318140630)
Replaces:
Homelite 01201, UP04802
McCulloch 225834-00
Shindaiwa 20036-81670
Stihl 4133 121 2700
Walbro 188-12, 188-12-1, 188-14, 188-
14-1
Stens 615-740
Fits: Walbro WA, WT, WY, WYJ, WYK, WYL, WYP, and
WYZ carburetors that require a 3/4” OD x 9/16” HT purge
bulb.
WARNING
Failure to follow these safety instructions when performing maintenance repair could result in severe personal injury or
property damage.
• If you are not comfortable performing any of the functions described in these instructions, take your unit to an autho-
rized servicing dealer
• Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop and allow
unit to cool before servicing unit. Wear gloves to protect hands from sharp edges and hot surfaces.
• Work in a well-ventilated area, away from open ames or sparks.
• Drain fuel from tank and store in an approved container a minimum of 10 feet away from the work area.
• See operator’s manual for complete maintenance schedule and procedures.
WARNING
To reduce the risk of injury, read and understand the op-
erator’s manual for your unit, and this instruction sheet. Al-
ways wear eye protection that complies with ANSI Z87.1.
Ensure compatibility and t before using this accessory.
Do not use this accessory if a part is damaged or missing.
INSTALLATION INSTRUCTIONS
PURGE BULB KIT
DANGER:
Fuel is VERY ammable. Use extreme care when mix-
ing, storing or handling, or serious personal injury may
result.
Remote Purge Bulb (12318139130)
Replaces:
Homelite/Jacobsen 1123
MTD 791-683974
McCulloch 224242-01
Oregon 07-073
Ryan/Ryobi 683974
Stens 615-764
Stihl 4130-350-6200
Tanaka 442-25143-800
Walbro 188-512, 188-512-1