Use and Care Manual

b l a d e r e p l a c e m e n t /l u b r I c a t I o n

Level 1.

Parts Required: POWER BLENDX

8 oz. (P/N 91014) or Lithium

Base Grease, Blade P/N 69601552632, split pin P/N

90030020022

Gear Case

NOTE

Grease gear case every 15 - 25 hours of use. Replace blade when it

is worn shorter than 6 in. Remove blade and holders before greas-

ing to prevent damage to gear and bearings.

1. Shut engine off.

2. Remove split pin (A).

3. Rotate blade until holes in inner blade adapter (B) and gear box

align. Insert locking tool to lock PTO shaft (C).

NOTE

Blade nut (D) is left hand thread.

4. Remove blade nut (D) in a clockwise direction using a wrench.

Remove outer blade adapter (E), blade (F) and inner blade adapter

(B).

s k I l l l e v e l

Level 1 = Easy to do. Common tools may be required.

Level 2 = Moderate difculty. Some specialized tools may be required.

m a I n t e n a n c e I n t e r v a l s

Component Maintenance Procedure Skill Level Interval

Drive Shaft Grease 1 Every 25 hours of use [1]

Gear Housing Grease 1 Every 15-25 hours of use [1]

Screws/Nuts/Bolts Inspect/Tighten/Replace 1 Before Each Use

IMPORTANT - Time intervals shown are maximum. Actual use and your experience will determine the frequency

of required maintenance.

[1] Apply POWER BLENDX

Grease.