Owner's Manual

Drive Shaft (Lower)

IMPORTANT

Lower and upper drive shaft must be lubricated with high tem-

perature automotive grease every 25 hours of operation, otherwise

drive shaft assembly overheating and failure can result.

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull exible cable from the drive shaft housing, wipe clean and

re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the exible cable back in the drive housing. DO NOT get

dirt on the ex cable.

4. Install the gear housing and shield assembly.

IMPORTANT

Flat edge of washers (D) must be against drive shaft.

nylon lIne replacement

Level 1.

Parts Required: ECHO 0.095" Nylon Trimmer Line 6 m (20 ft.) long.

1. Shut engine off. Lay unit on the ground with head assembly up.

2. Hold drum (A) and rmly turn spool (B) CW (clockwise) until it

disengages from the inner drive. Pull spool from drum. DO NOT

push in on spool when turning.