Owner's Manual

contents

The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions,

shield installation and other assembly may be necessary.

After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing

parts. Use the contents list to check for missing parts.

_____ 1 - PAS Hi Torque Trimmer Attachment

_____ 1 - Operator's Manual

_____ 1 - Safety Manual

_____ 1 - Warranty Registration Card

_____ 1 - Locking Tool

_____ 1 - T-Wrench

_____ 1 - Plastic Debris Shield

_____ 1 - Nylon Trimmer Head

_____ 1 - Safety Goggle

_____ 1 - Shield Plate

_____ 3 - 5mm x 16mm Screws (shield mounting)

_____ 1 - Storage Hook Assembly

Tools Required: None

Parts Required: PAS or SRM-SB Power Head w/Shaft & Coupling.

1. Set Power Head/Shaft Assembly on a level surface.

2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to lock-

out position.

3. Remove vinyl cap from attachment drive shaft.

4. Carefully t attachment drive shaft assembly into coupler (B) to

decal assembly line (C), making sure that the inner lower drive shaft

engages into the square upper drive shaft socket.

NOTE

Earlier model Power Heads may have shorter couplings. Short

couplings t ush to decal point (E). New couplings are 4-3/4 in.

long, and t ush to line (C).

NOTE

Lower bearing housing and head assembly must be in line with the

engine.

assembly

power

head shaft/lower shaft assembly