Use and Care Manual

ASSEMBLY 99944200601

14 X7712092600

ASSEMBLY

Power Head Shaft To Lower Shaft Assembly

Do not perform maintenance or assembly procedures with

engine running.

1. Set Power Head/Shaft Assembly on a level surface.

2. Pull locater pin (A) out, and turn counter-clockwise ¼

turn to lock-out position.

3. Remove vinyl cap from attachment drive shaft.

4. Remove cardboard spacer, if necessary.

Note: Your coupler may appear different than

coupler shown.

5. Carefully fit attachment drive

shaft assembly into coupler (B)

to decal assembly line (C),

making sure that the inner

lower drive shaft engages the

square upper drive shaft

socket.

Note: Earlier model power

heads may have shorter

couplings.

Note: Lower bearing housing

and head assembly must be in line with the engine.

6. Rotate locater pin (A) ¼ turn

clockwise to engage lower shaft

hole. Insure locater pin is fully

engaged by twisting lower drive

shaft. Locater pin should snap

flush in coupler. Full

engagement will prevent further

shaft rotation.

7. Secure lower shaft assembly to

coupler by tightening clamping

knob (D).

Install Handle/Barrier Bar

Note: The Barrier Bar is required when using grass or weed blades.

Units equipped with U-Handles do not require installation of

the Barrier Bar.

Parts Required: PAS or SRM-SB Power Head Shaft and Coupling