Owner's Manual

lubrICaTIon

Level 1.

Parts Required: POWER BLENDX

8 oz. or Lithium

Base Grease.

Gear Housing

1. Clean all loose debris from gear box.

2. Remove plug (A) and check level of grease. Grease should ll gear

case to bottom of grease plug hole.

3. Add grease if necessary using manual grease gun or squeeze-type

tube. Do not use high pressure grease gun. DO NOT over-ll.

4. Install plug (A).

Drive Shaft (Lower)

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull exible cable from the drive shaft housing, wipe clean and

re-coat with a thin coating [15 ml (1/2 oz.)] of LUBRICANTE

ECHO

3. Slide the exible cable back in the drive housing. DO NOT get

dirt on the ex cable.

4. Install the gear housing and shield assembly.

IMPORTANT

Flat edge of washers (D) must be against drive shaft.

maInTenanCe InTervals

skIll levels

Level 1 = Easy to do. Common tools may be required.

Level 2 = Moderate difculty. Some specialized tools may be required.

Component Maintenance Procedure Skill Level Interval

Drive Shaft Grease 1 Every 25 hours of use [1]

Gear Housing Grease 1 Every 50 hours of use [1]

Screws/Nuts/Bolts Inspect/Tighten/Replace 1 Before Each Use

IMPORTANT - Time intervals shown are maximum. Actual use and your experience will determine the frequency

of required maintenance.

[1] Apply POWER BLENDX

Grease.