Owner's Manual

PAS RAPid LoAdeR
TM
TRiMMeR ATTAchMenT
oPeRAToR'S MAnuAL
11
1. Insert pre-cut 204 mm (8 in.) length of nylon cut-
ting line (recommended sizes 2.4 mm [.095 in.]
to 3.9 mm [.155 in.]) through outside openings of
trimmer head. Minimum of 153mm (6 in.) of line
should extend from each opening. 3.9mm [.155 in.]
line not recommended for trimmers under 28cc.
Level 1.
Parts Required: Pre-cut Nylon Line
NOTE
Insert cutting line ends to center of head recess to insure easy
removal of used lines.
NOTICE:
Nylon line can damage plastic shield. When installing line seg-
ments, make sure line does not curve upward toward shield.
sTorage
Storage Hook Installation
1. Insert small end of hook into locating hole on attachment shaft.
2. Slide plastic cap onto end of attachment shaft.
Shaft Length ------------------------------------------------ 838 mm (33 in.)
Attachment Width ----------------------------------------- 178 mm (7 in.)
Attchment Height ------------------------------------------ 229 mm (9 in.)
Weight ------------------------------------------------------- 1.36 kg. (3.1 lb.)
Drive Shaft -------------------------------------------------- 6.35 mm (1/4 in.) Flex Shaft
Rotating Direction ----------------------------------------- Counter-clockwise viewed from the top
Cutter Head ------------------------------------------------- Rapid Loader
TM
head (2-lines) with .095 Cross Fire
TM
Line
speCIfICaTIons
PAS Rapid Loader
TM
Attachment
MODELS REQUIRED LINE SIZES
SRM-2100SB
SRM-210SB/211SB/225SB .080 - .105 in.
PAS-210/211/2100
PAS-225/225VP/225VBP
PAS-230/231
SRM-2400SB .095 - .105 in.
PAS -2400
SRM-260SB/261SB
PAS-2601 .095 - .130 in.
PAS-260/261
PAS-265/266
PAS-280 .095 - .155 in.
nylon lIne replaCemenT