PAS Rapid LoaderTM Curved Shaft Trimmer Attachment Operator's Manual PAS Rapid LoaderTM Curved Shaft Grass Trimmer Attachment Operator's Manual MODEL 99944200615 FOR MODELS: SRM-2100SB SRM-2400SB SRM-210SB/211SB SRM-225SB SRM-260SB/261SB PAS-2100 PAS-2400 PAS-2601 PAS-210/211 PAS-225 PAS-230/231 PAS-260/261 PAS-265 WARNING Read rules for safe operation and instructions carefully.
Introduction Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job dependability. Read and understand this manual and the SAFETY MANUAL you found in the same package. You will find both easy to use and full of helpful operating tips and SAFETY messages. the operator's manual Read and understand this manual before operation. Keep it in a safe place for future reference.
PAS Rapid LoaderTM Curved Shaft Trimmer Attachment Operator's Manual Safety manual safety symbols and important information Throughout this manual and on the product itself, you will find safety alerts and helpful, information messages preceded by symbols or key words. The following is an explanation of those symbols and key words and what they mean to you.
personal condition and safety equipment WARNING Trimmer users risk injury to themselves and others if the trimmer is used improperly or safety precautions are not followed. Proper clothing and safety gear must be worn when operating a trimmerr. Physical Condition Your judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well.
PAS Rapid LoaderTM Curved Shaft Trimmer Attachment Operator's Manual Repetitive Stress Injuries It is believed that overusing the muscles and tendons of the fingers, hands, arms and shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those areas. Certain repetitive hand activities may put you at a high risk for developing a Repetitive Stress Injury (RSI).
equipment Before operation a complete check of the unit must be performed; • Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed. • Inspect shield for damage. Replace if shield is damaged or missing. • Check that the cutting attachment is firmly attached and in safe operating condition. • Check that front loop handle is adjusted for safe, comfortable operation. See Assembly Section for proper adjustment.
PAS Rapid LoaderTM Curved Shaft Trimmer Attachment Operator's Manual 1. LOWER DRIVE SHAFT ASSEMBLY - Includes the Debris Shield Assembly, Gear Housing assembly, Flexible Drive Cable, Rapid LoaderTM Head and Safety Decal. 2. FLEXIBLE DRIVE CABLE - Cable end fits into upper drive shaft coupler. Lubricate drive cable every 25 hours with POWER BLENDXTM grease. 3. PLASTIC DEBRIS SHIELD ASSEMBLY - Included in plastic bag (co-pack). MUST be installed on unit before use, see Assembly Instructions.
Assembly WARNING Do not perform maintenance or assembly procedures with engine running. Parts Required: Plastic Shield Assembly plastic shield installation B Caution Wear Gloves or personal injury may result: • Cutoff knife is sharp. • Gearcase and surrounding area may be hot. 1. Remove wing nut (A), washer (B), and bolt (C). 2. Snap the shield over the bearing housing. 3. Install bolt (C), washer (B), and wing nut (A). nylon line head installation/removal 1.
PAS Rapid LoaderTM Curved Shaft Trimmer Attachment Operator's Manual power head shaft/attachment lower shaft assembly 1. Set Power Head/Shaft Assembly on a level surface. 2. Pull locator pin (A) and rotate counter clockwise 1/4 turn to lock out position. 3. Remove vinyl cap from attachment drive shaft. 4. Remove cardboard spacer, if necessary. 5.
Operation NOTE Refer to your Split Boom\Pro Attachment SeriesTM Operator's Manual for correct engine fueling, starting and stopping instructions. IMPORTANT Never wear line shorter than 1-1/2 inch extension from head, otherwise overspeeding and engine damage may result. Maintenance WARNING Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings.
PAS Rapid LoaderTM Curved Shaft Trimmer Attachment Operator's Manual 11 lubrication Level 1. Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium Base Grease. 1. 2. 3. 4. 5. Remove plastic shield. Loosen bearing housing locating screw (A), at the top of the housing, loosen mounting screw (B) and remove gear case from drive housing. Pull the flexible drive shaft (C) from the drive housing, wipe clean and recoat with a thin coating [1/2 oz. (15 ml)] of grease.
Storage Storage Hook Installation 1. Insert small end of hook into locating hole on attachment shaft. 2. Slide plastic cap onto end of attachment shaft. Specifications Length ������������������������������������������������������� 630 mm (24.8 in.) Width �������������������������������������������������������� 320 mm (12.6 in.) Height ������������������������������������������������������� 420 mm (16.53 in.) Weight ������������������������������������������������������� 1.09 kg. (2.4 lb.
PAS Rapid LoaderTM Curved Shaft Trimmer Attachment Operator's Manual notes 13
notes
PAS Rapid LoaderTM Curved Shaft Trimmer Attachment Operator's Manual notes 15
Servicing Information parts/serial number Genuine ECHO Parts and ECHO REPOWER™ Parts and Assemblies for your ECHO products are available only from an Authorized ECHO Dealer. When you do need to buy parts always have the Model Number, Type and Serial Number of the unit with you. You can find these numbers on the engine housing. For future reference, write them in the space provided below. Model No. _________________SN.
