MSDS

Echo Power Blend Two-Cycle Engine Oil
Storage
Keep container tightly closed. Store in a cool, dry, well-ventilated area. Store only in
approved containers. Do not store with oxidizing agents. Do not store at elevated
temperatures or in direct sunlight. Protect containers against physical damage. Head space
in tanks and other containers may containers may contain vapor in the flammable range.
Vapor may be ignited by static discharge. Storage area must meet OSHA requirements and
applicable fire codes.
Additional information regarding the design and control of hazards associated with the
handling and storage of flammable and combustible liquids may be found in professional and
industrial documents including, but not limited to, the National Fire Protection Association
(NFPA) publications NFPA 30 ("Flammable and Combustible Liquid Code"), NFPA 77
("Recommended Practice on Static Electricity") and the American Petroleum Institute (API)
Recommended Practice 2003, “Protection Against Ignitions Arising Out of Static, Lightning,
and Stray Currents' (liquids)."
A spill or leak can cause an immediate fire or explosion hazard. Keep containers closed and
do not handle or store near heat, sparks, or any other potential ignition sources. Avoid
contact with oxidizing agents. Do not breathe vapor. Use only with adequate ventilation and
personal protection. Never siphon by mouth. Avoid contact with eyes, skin, and clothing.
Prevent contact with food and tobacco products. Do not take internally.
When performing repairs and maintenance on contaminated equipment, keep unnecessary
persons away from the area. Eliminate all potential ignition sources. Drain and purge
equipment, as necessary, to remove material residues. Follow proper entry procedures,
including compliance with 29 CFR 1910.146 prior to entering confined spaces such as tanks
or pits. Use gloves constructed of impervious materials and protective clothing if direct
contact is anticipated. Provide ventilation to maintain exposure potential below applicable
exposure limits. Use appropriate respiratory protection when concentrations exceed any
established occupational exposure level (See Section 8). Promptly remove contaminated
clothing. Wash exposed skin thoroughly with soap and water after handling.
Non equilibrium conditions may increase the fire hazard associated with this product. Always
bond receiving containers to the fill pipe before and during loading. Always confirm that
receiving container is properly grounded. Bonding and grounding alone may be inadequate to
eliminate fire and explosion hazards. Carefully review operations that may increase the risks
such as tank and container filling, tank cleaning, sampling, gauging, loading, filtering, mixing,
agitation, etc. In addition to bonding and grounding, efforts to mitigate the hazards may
include, but are not limited to, ventilation, inerting and/or reduction of transfer velocities.
Always keep nozzle in contact with the container throughout the loading process. Do NOT fill
any portable container in or on a vehicle. Do NOT use compressed air for filling, discharging
or other handling operations.
Product container is not designed for elevated pressure. Do not pressurize, cut, weld, braze
solder, drill, or grind on containers. Do not expose product containers to flames, sparks, heat
or other potential ignition sources. Empty containers may contain product residues that can
ignite with explosive force. Observe label precautions. Consult appropriate federal, state and
local authorities before reusing, reconditioning, reclaiming, recycling or disposing of empty
containers and/or waste residues of this product.
Handling
Engineering Controls
Personal Protective
Equipment
Provide exhaust ventilation or other engineering controls to keep the airborne concentrations
of mists and/or vapors below the recommended exposure limits (see below). An eye wash
station and safety shower should be located near the work-station.
SECTION 8. EXPOSURE CONTROLS AND PERSONAL PROTECTION
Personal protective equipment should be selected based upon the conditions under which
this material is used. A hazard assessment of the work area for PPE requirements should
be conducted by a qualified professional pursuant to OSHA regulations. The following
pictograms represent the minimum requirements for personal protective equipment. For
certain operations, additional PPE may be required.
Continued on Next Page
Page Number: 4
MSDS No. Revision Date
6/15/2009
625478416