MSDS

Echo Power Blend Two-Cycle Engine Oil
Occupational Exposure Guidelines
Safety glasses equipped with side shields are recommended as minimum protection in
industrial settings. Wear goggles if splashing or spraying is anticipated. Wear goggles and
face shield if material is heated above 125°F (51°C). Have suitable eye wash water
available.
Avoid skin contact. Use heavy duty gloves constructed of chemical resistant materials such
as Viton® or heavy nitrile rubber. Wash hands with plenty of mild soap and water before
eating, drinking, smoking, use of toilet facilities or leaving work. DO NOT use gasoline,
kerosene, solvents or harsh abrasives as skin cleaners.
The need for respiratory protection is not anticipated under normal use conditions and with
adequate ventilation. If elevated airborne concentrations above applicable workplace
exposure levels are anticipated, a NIOSH-approved organic vapor respirator equipped with a
dust/mist prefilter should be used. Protection factors vary depending upon the type of
respirator used. Respirators should be used in accordance with OSHA requirements (29
CFR 1910.134).
Eye Protection
Respiratory Protection
Use good personal hygiene practices. Wash hands and other exposed skin areas with
plenty of mild soap and water before eating, drinking, smoking, use of toilet facilities, or
leaving work. DO NOT use gasoline, kerosene, solvents or harsh abrasives as skin
cleaners. Since specific exposure standards/control limits have not been established for this
product, the "Oil Mist, Mineral" exposure limits shown below are suggested as minimum
control guidelines.
General Comments
Use clean protective clothing if splashing or spraying conditions are present. Protective
clothing may include long-sleeve outer garment, apron, or lab coat. If significant contact
occurs, remove oil-contaminated clothing as soon as possible and promptly shower.
Launder contaminated clothing before reuse or discard. Wear heat protective boots and
protective clothing when handling material at elevated temperatures.
Hand Protection
Body Protection
Substance Applicable Workplace Exposure Levels
Oil Mist, Mineral
ACGIH (United States).
TWA: 5 mg/m
3
STEL: 10 mg/m
3
OSHA (United States).
TWA: 5 mg/m
3
Petroleum hydrocarbon distillates
ACGIH (United States).
TWA: 100 ppm
OSHA (United States).
TWA: 500 ppm
Not available.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES (TYPICAL)
Volatility
Melting/Freezing
Point
Boiling Range
Vapor Pressure
Specific Gravity
Vapor
Density
Solubility in
Water
AP 135 g/l VOC (w/v)
Not available.
0.87 (Water = 1)
>1 (Air = 1)
<0.1 kPa (<1 mm Hg) (at 20°C)
Negligible solubility in cold water.
77
Viscosity
(cSt @ 40°C)
Physical State
Liquid.
Color
Blue-green.
Odor
Petroleum.
pH
Not applicable
Flash Point
Closed cup: 68°C (154°F). (Pensky-Martens (ASTM D-93)) Open cup: 84°C (183°F) (Cleveland.).
Continued on Next Page
Page Number: 5
MSDS No. Revision Date
6/15/2009
625478416