Instruction v.2 Owner's manual

Instruction Sheet

Instructions

PN 77653-00

Rev. 042613

SUBJECT: CH4400 BELT GUIDE IN-

STALLATION, PN 77654-00

FITS MODELS: CH4400 - VIN

5VJAA001XDW003870 and below

Before inspecting or servicing any part of this machine,

shut off or disconnect power source and make sure all

moving parts have come to a complete stop.

WARNING

PURPOSE

This kit is to replace the existing one piece belt guide with

two separate belt guides. The two belt guides will offer lon-

ger belt life. To replace the belt guides proceed as follows.

BELT GUIDE INSTALLATION

1. Remove seven 5/16" bolts and side belt cover.

2. Remove four 5/16" bolts and top belt cover.

3. Remove the two 5/16" bolts and belt guide and dis-

card. DO NOT reuse hardware.

4. Engage belt engagement lever to apply tension to belt.

5. Install new belt guides using hardware included.

PAGE 1
Instructions 3. Remove the two 5/16" bolts and belt guide and discard. DO NOT reuse hardware. SUBJECT: CH4400 BELT GUIDE INSTALLATION, PN 77654-00 FITS MODELS: CH4400 - VIN 5VJAA001XDW003870 and below PURPOSE This kit is to replace the existing one piece belt guide with two separate belt guides. The two belt guides will offer longer belt life. To replace the belt guides proceed as follows.
PAGE 2
6. Belt guides should be set to a 1/8" gap between belt and belt guide. Torque the four bolts that hold the belt guides to 19 ft-lbs. 7. Position the belt engagement lever in the start position and reinstall the belt covers and hardware. 8. Start the machine. (If the chipper disk is rotating without the engagement lever engaged the belt guides will need to be moved slightly closer to the belt.) Make sure guides do not touch belt when engagement lever is engaged. 9.