Full Product Manual

Table Of Contents

CS-4510 ASSEMBLY

X7503352800 23

Instructions to Install Optional Kick Guard

to Bar

Tools Needed: Two 11 mm (7/16 in.)

Wrenches.

1. Install bolt (A) in rear hole (B) of

optional Kick Guard

and

through front hole (C) in guide

bar.

2. IMPORTANT: Dimple (D) in

optional Kick Guard

must

engage recess (E) in guide bar.

3. Securely tighten nut (F) and

bolt (A).

Guide Bar and Saw Chain Installation / Removal

Note: Align the brake connector (B) of the sprocket guard to the

groove on the side of the brake lever (Front hand guard).

1. Remove air filter cover and

disconnect spark plug lead.

2. Move the chain brake lever (A)

(Front hand guard) fully

REARWARD (UNLOCK chain

brake) to remove or install the

sprocket guard (C).

3. Remove sprocket guard nuts

(D) and remove sprocket guard

(C).

4. Remove guide bar and saw

chain if necessary.

Note: See “Maintenance and

Care” section for guide

bar / saw chain

maintenance procedures.