Full Product Manual

Table Of Contents

ASSEMBLY CS-4510

24 X7503352800

5. Mount guide bar on studs (E)

and slide toward clutch drum

(F) to make saw chain

installation easier. Install saw

chain around sprocket and

guide bar as shown, with

cutters on top of guide bar

facing forward.

6. Install sprocket guard over

guide bar studs. Ensure chain

tension adjuster pin (H) fits into

the guide bar adjuster hole (G),

brake band (J) is positioned

around clutch drum (F). Tighten

sprocket guard nuts finger tight.

7. Turn saw over, and check brake

band (J) for correct position on

clutch drum. If brake band is

not in place around drum,

remove sprocket guard, and

reinstall. Tighten sprocket

guard nuts finger tight.

8. Adjust saw chain tension, as

instructed in “Adjustment,

Chain Tension”.

Improper sprocket guard assembly can result in serious injury,

and will cause severe saw damage if unit is started. Never start

or operate saw if brake band is not in place on clutch drum.

Always check chain brake operation after replacing guard. Do

not use saw if chain brake does not function properly.