Full Product Manual

Table Of Contents

MAINTENANCE CS-4510

48 X7503352800

Note: Federal EPA regulations require all model year 2012 and

later gasoline powered engines produced for sale in the

United States to be equipped with a special low permeation

fuel supply hose between the carburetor and fuel tank. When

servicing model year 2012 and later equipment, only fuel

supply hoses certified by EPA can be used to replace the

original equipment supply hose. Fines up to $37,500 may be

enforced for using an un-certified replacement part.

Automatic Oiler

• The discharge volume of the

automatic oiler is adjusted to

approximately 7 mL/min at 7000 r/

min, prior to shipment from

factory.

• Always check oil discharge when

in use.

• Turn adjusting screw (A) counterclockwise to increase oil volume,

clockwise to decrease oil volume. When the screw touches stopper and

stops, this position indicates maximum discharge volume. (13 mL/min at

7,000 r/min).

• Do not turn the adjusting screw beyond the maximum or minimum limit of

volume adjustment.

Oil Filter

• Check periodically.

• Do not allow dust to enter into oil

tank.

• A clogged oil filter (A) will affect

the normal lubricating system.

1. Remove the oil cap (B) and

pull oil filter (A) out through oil port, and inspect filter.

2. If the filter is dirty, wash it in gasoline or replace it as follows:

3. Do not remove the wire coil clamp to remove the oil filter (A). Pinch the

filter with the fingers on one hand and the line with the other hand. Pull

and twist slightly to separate.

4. Install the new oil filter (A) with the reverse action.

5. When the inside of the tank gets dirty, rinse the tank out with gasoline to

clean it.