Use and Care Manual

Table Of Contents

MAINTENANCE DPAS-2600SB

38 X7508230800

When the wear indicators

located at the bottom of the

Speed-Feed

head are worn

smooth, or if holes appear,

replacement of the cover or the

entire Speed-Feed

head

required.

Sharpening Metal Blades

Metal blades are very sharp and can cause severe injuries, even

if unit is off and blades are not moving. Avoid contact with

blades. Wear gloves to protect hands.

Several styles of metal blades are

approved for use on the

Brushcutter. The 8-tooth blade can

be sharpened during normal

maintenance. The clearing blade

and 80-tooth blade require

professional service.

Before sharpening, CLOSELY

inspect blade for cracks (look at the

bottom of each tooth and the center

mounting hole closely), missing

teeth and bending. If ANY of these

problems are discovered, replace

the blade.

When sharpening a blade, always

remove the same amount of materials from each tooth to maintain balance.

A blade that is not balanced will cause unsafe handling due to vibration and

can result in blade failure.