Use and Care Manual

OPERATION GT-225

22 X7732273902

2. Choke

Move choke (B) to COLD START

( ) (closed) position.

3. Purge Bulb

Pump purge bulb (C) until fuel is

visible and flows freely in the

clear fuel tank return line. Pump

bulb an additional 4 or 5 times.

4. Recoil Starter

Lay the unit on a flat area and

keep movable attachment parts

clear of all obstacles. Firmly

grasp throttle handle with left

hand and fully depress throttle

trigger to wide open position.

Rapidly pull recoil starter

handle/rope (D) until engine

fires (or maximum five pulls).

5. Choke

After engine fires (or 5 pulls), move choke (B) to the RUN ( ) (open)

position. Firmly grasp throttle handle with left hand and fully depress

throttle trigger to wide open position. Pull starter handle/rope until engine

starts and runs. Release throttle trigger and allow unit to warm up at idle

for several minutes.

Note: If engine does not start with choke in “RUN” position after 5

pulls, repeat instructions 2 - 5.

6. Throttle Trigger

After engine warm-up, grip throttle handle and support handle. Gradually

depress throttle trigger to increase engine RPM to operating speed.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO NOT close the

choke, and do not depress throttle trigger to wide open position.

The attachment should not move at idle, otherwise serious

personal injury may result.