Use and Care Manual

MAINTENANCE GT-225

26 X7732273902

* Replacement is recommended based on the finding of damage or wear

during inspection.

Air Filter

Level 1.

1. Close choke (COLD START [ ] position). This prevents dirt from

entering the carburetor throat when the air filter is removed. Brush

accumulated dirt from air cleaner area.

2. Remove air filter cover. Brush

dirt from inside cover.

3. Replace filter if it is damaged,

fuel soaked, very dirty, or the

rubber sealing edges are

deformed.

• Lightly brush debris from

filter.

• Soak heavily soiled filters in

water/detergent solution to

loosen dirt, then brush

lightly.

• Rinse with clean water and

allow to dry completely before reuse.

4. Install air filter in air filter case.

5. Install air filter cover.

Parts Required: Tune-Up Kit