PAS 80 Tooth Blade Trimmer Attachment Operator's Manual PAS 80 Tooth Blade Brushcutter Attachment 99944200600 Operator's Manual FOR MODELS: SRM-2100SB TYPE 1/1E SRM-2400SB TYPE 1/1E SRM-210SB/211SB/225SB SRM-260SB/261SB PAS-2100 TYPE 1E PAS-2400 TYPE 1E PAS-2601 TYPE 1E PAS-210/211/225 PAS-230/231 PAS-260/261/265 warning Read rules for safe operation and instructions carefully.
Introduction Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job dependability. Read and understand this manual included with your attachment. You will find this manual easy to use and full of helpful operations tips and SAFETY messages. the operator's manual Contains specifications and information for operation, starting, stopping, maintenance, storage, and assembly specific to this product.
PAS 80 Tooth Blade Trimmer Attachment Operator's Manual Safety manual safety symbols and important information Throughout this manual and on the product itself, you will find safety alerts and helpful, informational messages preceded by symbols or key words. The following is an explanation of those symbols and key words and what they mean to you.
personal condition and safety equipment WARNING Users of this product risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating unit. Physical Condition Your judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well.
PAS 80 Tooth Blade Trimmer Attachment Operator's Manual Repetitive Stress Injuries It is believed that overusing the muscles and tendons of the fingers, hands, arms, and shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those areas. Certain repetitive hand activities may put you at a high risk for developing a Repetitive Stress Injury (RSI).
equipment warning Use this attachment with ECHO approved models only. Serious injury may result from the use of this attachment combined with a non approved ECHO product. Before operation a complete check of the unit must be performed; • • • • • Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed. Inspect shield for damage and make sure it is securely in place. Replace if shield is damaged or missing.
PAS 80 Tooth Blade Trimmer Attachment Operator's Manual Debris Shield Decal Shaft Decals P/N X505002500 P/N 89016841031 1. LOWER DRIVE SHAFT ASSEMBLY - Includes the Debris Shield Assembly, Gear Housing assembly, Flexible Drive Cable, Metal Blade and Safety Decals. 2. FLEXIBLE DRIVE CABLE - Cable end fits into upper drive shaft coupler. Lubricate drive cable every 25 hours with Echo® LubeTM grease. 3. METAL BLADE SHIELD - Required when unit is equipped with blades. Do not operate unit without shield.
Assembly WARNING Do not perform maintenance or assembly procedures with engine running. Parts Required: Power Head Shaft, Attachment Lower Shaft Assembly, Metal Shield, Bracket, Barrier Bar power head shaft/attachment lower shaft assembly 1. Set Power Head/Shaft Assembly on a level surface. 2. Pull locator pin (A) and rotate counter clockwise 1/4 turn to lock out position. 3. Remove vinyl cap from attachment drive shaft. 4. Remove cardboard spacer, if necessary. B D A 5.
PAS 80 Tooth Blade Trimmer Attachment Operator's Manual install handle/barrier bar NOTE The Barrier Bar is required when using grass or weed blades. Units equipped with U-Handles do not require installation of the Barrier Bar. 1. Remove screws and nuts and back plate from handle. 4-screw front handles 2. 3. Position front handle on shaft and install Barrier Bar using four (4) 5x35 mm screws and (4) new nuts included with kit. Handle must be at least 10 inches (250 mm) from center of rear handle grip.
balance unit 1. Put on harness and attach unit to harness. 2. Slide harness clamp up and down until unit balances with head approximately 2 - 3 in. from the ground. 3. Tighten clamp screw. 2 - 3" NOTE In case of Emergency, the trimmer/brushcutter can be released from the the harness by pulling up on the quick-release collar. Operation NOTE Refer to your Split Boom\Pro Attachment SeriesTM Operator's Manual for correct engine fueling, starting and stopping instructions.
PAS 80 Tooth Blade Trimmer Attachment Operator's Manual skill levels Level 1 = Level 2 = Easy to do. Common tools may be required. Moderate difficulty. Some specialized tools may be required. maintenance intervals Component Maintenance Procedure Skill Level Interval Drive Shaft Grease 1 Every 25 hours of use Gear Housing Grease 1 Every 50 hours of use Screws/Nuts/Bolts Inspect/Tighten/Replace 1 Before Each Use IMPORTANT - Time intervals shown are maximum.
Storage Storage Hook Installation 1. Insert small end of hook into locating hole on attachment shaft. 2. Slide plastic cap onto end of attachment shaft. Specifications PAS 80 Tooth Blade Attachment Shaft Length ������������������������������������������������ 870 mm (34.3 in.) Attachment Width ����������������������������������������� 280 mm (11 in.) Attchment Height ������������������������������������������ 255 mm (10 in.) Weight (dry) w/blade �������������������������������������� 1.5 kg. (3.
PAS 80 Tooth Blade Trimmer Attachment Operator's Manual notes 13
notes
PAS 80 Tooth Blade Trimmer Attachment Operator's Manual notes 15
Servicing Information parts/serial number Genuine ECHO Parts and ECHO REPOWER™ Parts and Assemblies for your ECHO products are available only from an Authorized ECHO Dealer. When you do need to buy parts always have the Model Number and Serial Number of the unit with you. You can find these numbers on the engine housing. For future reference, write them in the space provided below. Model No. _____________ SN. ____________ service DEALER? Call 1-800-432-ECHO or www.echo-usa.