Use and Care Manual

ASSEMBLY PAS-2620

16 X7502342500

1. Set Power Head/Shaft Assembly on a level surface.

2. Pull locater pin (A) out, and turn counter-clockwise ¼

turn to lock-out position.

3. Remove vinyl cap from attachment drive shaft.

4. Remove cardboard spacer, if necessary.

Note: Your coupler may appear different than cou-

pler shown.

5. Carefully fit attachment drive

shaft assembly into coupler (B)

to decal assembly line (C),

making sure that the inner

lower drive shaft engages the

square upper drive shaft

socket.

Note: Earlier model power

heads may have shorter

couplings.

Note: Lower bearing housing

and head assembly must be in line with the engine.

6. Rotate locater pin (A) ¼ turn

clockwise to engage lower shaft

hole. Insure locater pin is fully

engaged by twisting lower drive

shaft. Locater pin should snap

flush in coupler. Full engage-

ment will prevent further shaft

rotation.

7. Secure lower shaft assembly to

coupler by tightening clamping

knob (D).

Support Handle Installation

Note: Label shows minimum

spacing for support han-

dle location.

1. If necessary, position support

handle for comfortable opera-

tion and securely tighten

screws.

MINIMUM

SPACING