Use and Care Manual

MAINTENANCE PAS-2620

32 X7502342500

4. Remove coupler from upper

drive shaft assembly by loosen-

ing clamping screw (C) and

removing set screw (D).

5. Remove upper flex cable (E),

wipe clean, and apply a thin

coating of 15 ml (0.5 oz.) of

grease.

6. Install cable. Make sure that the

flex cable fully engages into the

clutch square drive socket.

7. Slide coupler on upper drive

shaft until fully seated, and

align set screw hole in coupling with hole in upper drive shaft.

8. Install and tighten set screw (D), and tighten clamping screw (C).