Instructions / Assembly

© 09/2023 ECHO Incorporated X7151200500
16
Quick Start Guide / Guía de inicio rápido / Guide de démarrage rapide
PB-9010 H/T
Ajustar arnés
1. Tirez les sangles (C) vers le bas pour
régler harnais d’épaule.
2. Ajustez la sangle limitatrice (D) du
harnais an de rendre l’utilisation
plus confortable.
Para la comodidad del operador en operaciones en climas fríos
AVERTISSEMENT
Este producto no debe usarse a temperaturas inferiores a 15 ° F (-9 ° C);
de lo contrario, se pueden dañar las líneas de combustible.
A
1. Retire los clips del cojín del respaldo.
Retire el cojín del respaldo (A) del
bastidor.
B
2. Instale el inserto para clima frío (B)
en el marco sobre la toma de aire.
A
3. Instale el cojín del respaldo (A) en el
marco sobre el inserto para clima frío.
Nota: El rendimiento del soplador puede
reducirse ligeramente.
MAINTENANCE
Idle Speed Adjustment
NOTICE
Every unit is run at the factory and the carburetor is set in compliance with
emission regulations. Carburetor adjustments, other than idle speed, must be
performed by an authorized ECHO dealer.
If a tachometer is available, idle speed screw should be set to the specications
found on “Specications” page of the operator manual. Turn idle screw
clockwise to increase idle speed; counterclockwise to decrease idle speed.
Emissions Control Components
NOTICE
• The use of emission control components other than those specically
designed for this unit is a violation of federal law.
1. Air Filter: Close choke, remove air lter cover, clean air cleaner area, clean
or replace lters (if damaged).
2. Spark Plug:
Use only NGK CMR7H spark plug otherwise severe engine damage may occur.
Adjust spark plug gap by bending outer electrode to a 0.65 mm (0.026 in) gap.
DANGER
• Fuel is VERY ammable. Use extreme care when mixing, storing or
handling, or serious personal injury may result.
1. Fuel Filter replacement: Use a clean rag to remove loose dirt from around
fuel cap and empty fuel tank. Pull the fuel lter from the fuel tank. Remove
the lter from the line and install the new lter (do not damage fuel line
when removing the fuel lter from the tank).
Transportation
WARNING
• During operation the muer or catalytic muer and surrounding
cover become hot. Always keep exhaust area clear of ammable debris
during transportation or when storing, otherwise serious property
damage or personal injury may result.
• Always secure the unit during transportation to prevent turnover, fuel
spillage, and damage to the unit.
Short-term Storage
DANGER
• Store unit in a dry, dust free place, out of the reach of children.
• Do not store in enclosure where fuel fumes may accumulate or reach
an open ame or spark.
Long-term Storage (Over 30 Days)
NOTICE
• Place the stop switch in the “OFF” position.
• Clean the exterior of the product.
• Perform all periodic maintenance.
• Tighten all the screws and nuts.
• Drain the fuel and run the unit until it stops.
• Allow engine to cool.
• Store unit in a dry, dust free place, out of the reach of children.
D
C
C
C
C