Use and Care Manual

STORAGE PE-225

38 X7732272802

6. Drain fuel tank completely. Press purge bulb 6-7 times to remove

remaining fuel from carburetor then drain the tank again. Close choke,

start and run the engine until it stops due to lack of fuel.

7. Allow engine to cool. Remove the spark plug lead from the spark plug.

Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke

engine oil into the cylinder through the spark plug hole.

8. Pull the recoil starter handle 2-3 times to distribute the oil inside the

engine.

9. Observe the piston location through the spark plug hole. Pull the recoil

handle slowly until the piston reaches the top of its travel and leave it

there.

10. Install the spark plug. Connect the spark plug lead to the spark plug.