Use and Care Manual

SAFETY PE-2620

12 X7502341200

Equipment

Use only ECHO attachments. Serious injury may result from

the use of a non-approved attachment combination. ECHO,

INC. will not be responsible for the failure of cutting devices,

attachments or accessories which have not been tested and

approved by ECHO. Read and comply with all safety

instructions listed in this manual and safety manual.

• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace

as needed.

• Inspect shield for damage and that shield is securely in place. Replace if

shield is damaged or missing.

• Check that the cutting attachment is firmly attached and in safe operating

condition.

• Check that support handle is adjusted for safe, comfortable operation. See

Assembly Section for proper adjustment.

Moving parts can amputate fingers or cause severe injuries. Keep

hands, clothing and loose objects away from all openings.

◆ ALWAYS stop engine, disconnect spark plug, and make sure

all moving parts have come to a complete stop before

removing obstructions, clearing debris, or servicing unit.

◆ DO NOT start or operate unit unless all guards and protective

covers are properly assembled to unit.

◆ NEVER reach into any opening while the engine is running.

Moving parts may not be visible through openings.

Periodically Check fuel system (fuel lines, vent, grommet,

fuel tank, and fuel cap) for leaks especially if the unit is

dropped. If damage or leaks are found, do not use unit,

otherwise serious personal injury or property damage may

occur. Have unit repaired by an authorized servicing dealer

before using