Use and Care Manual

X7502341200 33

PE-2620 MAINTENANCE

ENGLISH

Note: Your debris shield may

appear different than

the debris shield

shown.

Gear Housing

1. Remove plug (A) and add

grease to gear housing. Do

not over-fill.

2. Replace plug and tighten

securely.

Drive Shaft

1. Loosen screw (B) and

remove center locating screw

(C). Pull gear box and shield

from drive shaft housing.

2. Pull flexible cable from the

drive shaft housing, wipe

clean and re-coat with a thin

coating (15 ml [1/2 oz.]) of

grease.

3. Slide the flexible cable back

in the drive housing. DO NOT get dirt on the flex cable.

4. Install the gear housing and shield assembly. Align locating screw hole with

hole in drive shaft housing.

5. Tighten screws securely.

Edger Blade Replacement

Level 1.

Note: Replace blade when it is bent, damaged, or worn shorter than 6

inches.

Parts Required: Blade, new split pin