Edger User Manual

as s e m b l y

Tools Required: 4 mm Hex Wrench, 8 x 10 mm Open-end Wrench

Parts Required: Power head, Drive Shaft Assembly

d r I v e s h a f t /p o w e r h e a d

1. Stand power head upright on a level surface.

2. Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft

clamp, and remove center drive shaft location bolt (A).

3. Remove dust cap and carefully t drive shaft assembly to engine

making sure that inner drive shaft engages into clutch mount.

4. Turn drive shaft housing until locating hole lines up with location

hole in clamp and install center drive shaft location bolt (A).

NOTE

Gear Housing must be aligned properly with engine. Aligning cen-

ter locating hole in driveshaft housing with center drive shaft bolt

(A) provides correct alignment.

co n t e n t s

The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions,

some assembly may be necessary.

After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing

parts. Use the contents list to check for missing parts.

___ 1, Power Head

___ 1, Drive Shaft Assembly

___ 1, Plastic Bag (Co-Pack)

___ 1, Operator's Manual

___ 1, Safety Manual

___ 1, Warranty Registration Card

___ 1, Front Handle

___ 1, Lower Bracket, Front Handle

___ 4, 5 x 35 mm screws

___ 1, T-Wrench

___ 1, Torx T27 L-Wrench (PE-265S Only)

___ 2, Split pin

___ 1, 4 mm Hexagon Wrench

___ 1, Locking Tool

___ 1, 8 x 10 mm Spanner Wrench

___ 1, Safety Glasses