Edger User Manual

Po w e r ed g e r

oP e r a t o r 's Ma n u a l

d r I v e s h a f t l u b r I c a t I o n

Level 1.

Tools required: 8 mm Open End Wrench, Torx T27 L-Wrench

(PE-265S), 4mm Hex Wrench (PE-265),

Clean rag

Parts Required: POWER BLENDX

8 oz. (P/N 91014) or Lithium

Base Grease.

1. Loosen two (2) screws (A) and remove center locating screw (B).

Pull gear box and shield from drive shaft housing.

2. Pull exible cable from the drive shaft housing, wipe clean and

recoat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the exible cable back in the drive housing. DO NOT get

dirt on the ex cable.

4. Install the gear housing and shield assembly.

b l a d e r e p l a c e m e n t /l u b r I c a t I o n

Level 1.

Tools Required: T-wrench, Locking Tool, Needle Nose Pliers,

13 mm Open End Wrench

Parts Required: POWER BLENDX

8 oz. (P/N 91014) or

Lithium Base Grease, Blade P/N 69601552632,

split pin P/N 90030020022

NOTE

Grease gear case every 15 - 25 hours of use. Replace blade when

it is worn shorter than 6 inches. Remove blade and adapters before

greasing to prevent damage to gear and bearings.

1. Shut engine off. Disconnect spark plug lead from spark plug.

PE-265

PE-265S