Operator’s Manual RB-85/S Broadcast Spreader X7507840200 ©2/22 ECHO Inc.
INTRODUCTION RB-85/S INTRODUCTION Specifications, descriptions, and illustrative material in this literature are as accurate as possible. Specifications are subject to change without notice. Illustrations might include optional equipment and accessories, and might not include all standard equipment. Your equipment might appear slightly different than pictured equipment. Read and understand all provided literature.
RB-85/S SERVICING INFORMATION SERVICING INFORMATION Parts and Serial Number Genuine ECHO parts and assemblies for your ECHO products are available only from an Authorized ECHO Dealer. When you do need to buy parts always have the model number and serial number of the unit with you. For future reference write them in the space provided below. Model No. _____________________ Serial No.
SAFETY RB-85/S SAFETY Safety Information Carefully read these instructions before use. Improper use or failure to follow instructions can result in product failure or injuries. For safe use of this product you must read and follow all instructions before using. Cancer and Reproductive Harm www.P65Warnings.ca.gov ◆ ◆ ◆ ◆ 4 Do not allow anyone to operate the broadcast spreader without proper instructions. Do not permit children to operate the broadcast spreader.
RB-85/S DESCRIPTION DESCRIPTION Locate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you understand and follow the instructions on it. If a decal cannot be read, a new one can be ordered from your dealer. The safety decal is for example only. Your label may appear slightly different. 6 7 1 5 2 4 3 ECHO Scotts Earthway LESCO With the spreader gate closed, fill spreader hopper. / Con la puerta del distribuidor cerrada, llene la tolva del distribuidor.
CONTENTS 1 Handles 2 Hopper 3 Wheels 4 Adjustable Deflector 5 Upper Control Rod 6 Gate Control Lever 7 Gate Adjustment Limiter RB-85/S CONTENTS The product you purchased has been partially factory pre-assembled for your convenience. Due to packaging restrictions, some assembly may be necessary. After opening the carton, check for damage. Immediately notify your retailer or Dealer of damaged or missing parts. Use the contents list to check for missing parts.
RB-85/S 1 ASSEMBLY Warranty Statement ASSEMBLY Install Wheels and Handle 1. Install right wheel and secure with washer (A) cotter pin (B). A B 2. Install left wheel and secure with 6 x 50 mm bolt (C) and 6 mm flange nut (D). C D X7507840200 ©2/22 ECHO Inc.
ASSEMBLY 3. Install upper handle assembly (E) into lower handle bracket (F). Attach hinge (G) oriented as shown, and secure with two 6 x 60 mm bolts (H) and two 6 mm flange nuts (I). RB-85/S E H F I G Install Control Rods 1. Insert tab end of upper control rod (A) into slotted hole in gate control lever (B). Turn rod clockwise until it is parallel with handle assembly. B A 8 X7507840200 ©2/22 ECHO Inc.
RB-85/S 2. ASSEMBLY Thread 6 mm nut (C) onto end of upper control rod to a distance of 25.4 mm (1 in) from bottom of rod. Insert threaded end of rod into hole in hinge arm (D). Then thread 6 mm flange nut (E) onto rod. C D 1.0 in (25 mm) E 3. Insert lower control rod (F) into hinge (G), as shown. G F 4. Insert other end of lower control rod into hole in gate control (H), as shown, and secure with clevis pin (I). Note: Some parts removed from graphic for clarity. H I X7507840200 ©2/22 ECHO Inc.
ASSEMBLY 5. RB-85/S Pull lower control rod (F) backward until gate is fully closed. F 6. 10 Position gate control lever fully forward, and tighten upper control rod nut and flange nut as shown. X7507840200 ©2/22 ECHO Inc.
RB-85/S ASSEMBLY Install Grate 1. Align notches in grate (A) with tabs (B) in hopper. Install grate into hopper. Turn grate clockwise to lock into place. A B B B Rear Deflector 1. Install rear deflector (A) as shown. A X7507840200 ©2/22 ECHO Inc.
ASSEMBLY RB-85/S Change Auger Note: Refer to operation section for information on selecting correct auger. 1. Remove grate. 2. Remove flange nut (A) and bar auger (B) from gear shaft. A B 3. Install spiked auger (C) onto gear shaft and secure with flange nut (B). 4. Reinstall grate. A C Assure spiked auger is oriented as shown. 12 X7507840200 ©2/22 ECHO Inc.
RB-85/S OPERATION Check Tire Pressure Tires should be inflated to 15 psi. Assure tire pressure does not exceed 30 psi. OPERATION Application Instructions TIP HAZARD. Unit can tip on uneven ground. Always fill hopper on flat ground, and keep bystanders away. Otherwise personal injury can result. 1. Adjust deflector (C) to desired angle for spreading range. C 2. Pull gate control lever backward to set gate to desired opening size. Use gate adjustment limiter (B) to restrict gate opening size.
OPERATION 3. RB-85/S Push gate control lever (A) fully forward to close gate. Fill hopper with product. Fill hopper in an area that won’t be damaged by spilled product. A 4. Start spreader in motion, and pull gate control lever back to begin the flow of product. 5. Move gate control lever forward to close gate before turning or stopping. Unit comes with bar auger factory installed.
RB-85/S MAINTENANCE Sample Spread Pattern Muestra del patrón de disribución Modèle d’épandageetyp SHUT OFF HERE Apague aquí Arrêt ici START Inicio Mise en marche SHUT OFF HERE Apague aquí Arrêt ici RESTART Reinicie Remise en marche RESTART Reinicie Remise en marche SHUT OFF HERE Apague aquí Arrêt ici RESTART Reinicie Remise en marche RESTART Reinicie Remise en marche SHUT OFF HERE Apague aquí Arrêt ici MAINTENANCE Cleaning Spreader Avoid spraying gear case directly, and do not use a pressure washer
MAINTENANCE RB-85/S Lubrication C A Lubricate gear case and axle once per season. 1. C A Gear case and Axle: Clear debris from grease fittings (A). Apply 1-2 pumps of lithium-based grease with appropriate grease gun. Clean excess grease from grease fittings. A 16 A X7507840200 ©2/22 ECHO Inc.
RB-85/S SPECIFICATIONS SPECIFICATIONS MODEL RB-85 Length 1,194 mm (47 in) Width 654 mm (25.75 in) Height 952 mm (37.50 in) Weight 16.20 kg (35.80 lb) Capacity Weight 38.50 kg (85lb.) Volume 43.90 L (1.55 ft3) Loading Height 641 mm (25.25 in) Wheels and Tires Tire Diameter 305 mm (12 in) Tire Type Pneumatic Recommended Pressure 103.4 kPa (15 psi) X7507840200 ©2/22 ECHO Inc.
PRODUCT REGISTRATION RB-85/S PRODUCT REGISTRATION Thank you for choosing ECHO Power Equipment Please go to http://www.echo-usa.com/Warranty/Register-Your-ECHO to register your new product on-line. It's FAST and EASY! NOTE: your information will never be sold or misused by ECHO, Incorporated. Registering your purchase enables us to contact you in the unlikely event of a service update or product recall, and verifies your ownership for warranty consideration.
PRODUCT REGISTRATION ECHO Incorporated RB-85/S X7507840200 ©2/22 ECHO Inc.
N30900001001 - N3090000999999 N30700001001 - N3070000999999 ECHO INCORPORATED 400 Oakwood Road Lake Zurich, IL 60047 www.echo-usa.