Operator's Manual
Table Of Contents
- Table of Contents
- IIntroduction 3
- Servicing Information 3
- Parts/Serial Number 3
- Service 4
- ECHO Consumer Product Support 4
- Product Registration 4
- Additional Literature 4
- Safety 5
- Manual Safety Symbols and Important Information 5
- International Symbols 6
- Personal Condition and Safety Equipment 8
- Equipment 12
- Emission Control
- (Exhaust & Evaporative) 14
- CARB And EPA Emissions Control Information 14
- Description 15
- Contents 16
- Assembly 17
- Support Handle Installation 17
- Operation 17
- Operation With Blades 18
- Blade Selection 19
- Fuel 21
- Starting Cold Engine 24
- Starting Warm Engine 25
- Stopping Engine 27
- Applications 27
- Operating Techniques 28
- Reaction Forces 28
- Blade Cutting Problems 29
- Maintenance 30
- Skill Levels 30
- Maintenance Intervals 31
- Air Filter 32
- Fuel Filter 33
- Spark Plug 34
- Cooling System 34
- Exhaust System 36
- Carburetor Adjustment 38
- Lubrication 39
- Nylon Line Replacement 40
- Sharpening Metal Blades 41
- Troubleshooting 43
- Storage 45
- Long Term Storage (Over 30 Days) 45
- Specifications 46
- Product Registration 48
- Introduction
- Servicing Information
- Parts/Serial Number
- Service
- ECHO Consumer Product Support
- Product Registration
- Additional Literature
- Safety
- Manual Safety Symbols and Important Information
- International Symbols
- Personal Condition and Safety Equipment
- Equipment
- Emission Control
- (Exhaust & Evaporative)
- CARB And EPA Emissions Control Information
- Description
- Contents
- Assembly
- Support Handle Installation
- Operation
- Operation With Blades
- Blade Selection
- Fuel
- Starting Cold Engine
- Starting Warm Engine
- Stopping Engine
- Applications
- Operating Techniques
- Reaction Forces
- Blade Cutting Problems
- Maintenance
- Skill Levels
- Maintenance Intervals
- Air Filter
- Fuel Filter
- Spark Plug
- Cooling System
- Exhaust System
- Carburetor Adjustment
- Lubrication
- Nylon Line Replacement
- Sharpening Metal Blades
- Troubleshooting
- Storage
- Long Term Storage (Over 30 Days)
- Specifications
- Product Registration
- Notes
MAINTENANCE SRM-225
34 X7732273804
© 11/19 ECHO Incorporated
Fuel Filter
Level 1.
Fuel is VERY flammable. Use extreme care when mixing, storing
or handling, or serious personal injury may result.
1. Use a clean rag to remove
loose dirt from around fuel
cap and empty fuel tank.
Do not damage fuel line while removing fuel filter from tank or line.
2. Pull the fuel filter from the tank.
3. Do not remove the wire coil clamp to remove the fuel filter. Pinch the
fuel filter with the fingers on one hand and the fuel line with the other
hand. Pull and twist slightly to separate.
4. Install the new filter with the reverse action.
Note: Federal EPA regulations require all model year 2012 and later
g
asoline powered engines produced for sale in the United
States to be equipped with a special low permeation fuel
supply hose between the carburetor and fuel tank. When
servicing model year 2012 and later equipment, only fuel
supply hoses certified by EPA can be used to replace the
original equipment supply hose. Fines up to $37,500 may be
enforced for using an un-certified replacement part.
Parts Required: TUNE UP KIT.