Operator's Manual
Table Of Contents
- Table of Contents
- IIntroduction 3
- Servicing Information 3
- Parts/Serial Number 3
- Service 4
- ECHO Consumer Product Support 4
- Product Registration 4
- Additional Literature 4
- Safety 5
- Manual Safety Symbols and Important Information 5
- International Symbols 6
- Personal Condition and Safety Equipment 8
- Equipment 12
- Emission Control
- (Exhaust & Evaporative) 14
- CARB And EPA Emissions Control Information 14
- Description 15
- Contents 16
- Assembly 17
- Support Handle Installation 17
- Operation 17
- Operation With Blades 18
- Blade Selection 19
- Fuel 21
- Starting Cold Engine 24
- Starting Warm Engine 25
- Stopping Engine 27
- Applications 27
- Operating Techniques 28
- Reaction Forces 28
- Blade Cutting Problems 29
- Maintenance 30
- Skill Levels 30
- Maintenance Intervals 31
- Air Filter 32
- Fuel Filter 33
- Spark Plug 34
- Cooling System 34
- Exhaust System 36
- Carburetor Adjustment 38
- Lubrication 39
- Nylon Line Replacement 40
- Sharpening Metal Blades 41
- Troubleshooting 43
- Storage 45
- Long Term Storage (Over 30 Days) 45
- Specifications 46
- Product Registration 48
- Introduction
- Servicing Information
- Parts/Serial Number
- Service
- ECHO Consumer Product Support
- Product Registration
- Additional Literature
- Safety
- Manual Safety Symbols and Important Information
- International Symbols
- Personal Condition and Safety Equipment
- Equipment
- Emission Control
- (Exhaust & Evaporative)
- CARB And EPA Emissions Control Information
- Description
- Contents
- Assembly
- Support Handle Installation
- Operation
- Operation With Blades
- Blade Selection
- Fuel
- Starting Cold Engine
- Starting Warm Engine
- Stopping Engine
- Applications
- Operating Techniques
- Reaction Forces
- Blade Cutting Problems
- Maintenance
- Skill Levels
- Maintenance Intervals
- Air Filter
- Fuel Filter
- Spark Plug
- Cooling System
- Exhaust System
- Carburetor Adjustment
- Lubrication
- Nylon Line Replacement
- Sharpening Metal Blades
- Troubleshooting
- Storage
- Long Term Storage (Over 30 Days)
- Specifications
- Product Registration
- Notes
MAINTENANCE SRM-225
36 X7732273804
© 11/19 ECHO Incorporated
Removal of cooling passage blockages or cleaning of cooling fins is
considered “Normal Maintenance.” Any failure attributed to lack of
maintenance is not warranted.
1. Remove spark plug lead.
2. Close choke (COLD START
[ ] position). This prevents
dirt from entering the
carburetor throat when the air
filter is removed. Remove air
cleaner cover (A).
3. Remove engine cover (B).
DO NOT use a metal scraper to remove dirt from the cylinder fins.
4. Use a brush to remove dirt
from the cylinder fins.
5. Remove ignition wires from
clip for cleaning.
A
B