Use and Care Manual

OPERATION SRM-225I

26 X7732274902

4. Recoil Starter

Lay the unit on a flat area and

keep movable attachment parts

clear of all obstacles. Firmly

grasp throttle handle with left

hand and fully depress throttle

trigger to wide open position.

Gently pull recoil starter handle/

rope (D) until engine fires or 2 to

3 engine engagements.

5. Choke

After engine fires, or 2 to 3 engine engagements, move choke lever (B) to

the Run position ( ). Firmly grasp throttle handle with left hand and fully

depress throttle trigger to wide open position. Gently pull starter handle/

rope until engine starts and runs. Release throttle trigger and allow unit to

warm up at idle for several minutes.

Note: If engine does not start with choke in “RUN” position after 2-3

engine engagements, repeat instructions 2 - 5.

6. Throttle Trigger

After engine warm-up, grip throttle handle and support handle. Gradually

depress throttle trigger to increase engine RPM to operating speed.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO NOT close the

choke, and do not depress throttle trigger to wide open position.

The attachment should not move at idle, otherwise serious

personal injury may result.

Note: If attachment moves, readjust carburetor according to

“Carburetor Adjustment” instructions in this manual or see

your ECHO Dealer.