Use and Care Manual

OPERATION SRM-225I

30 X7732274902

• Using the correct blade for the cutting job

• Using properly sharpened blades

• Applying consistent, even force to the blade

during the cut

• Avoiding obstacles and ground hazards

• Using extra care when cutting harder

materials such as extremely dry brush,

saplings, and small trees

• Cutting from a stable, secure position

Blade Cutting Problems

Binding - Blades may bind in the cut if dull or forced. Binding can damage

blade, and result in blade breakage or injury from fragments and flying

debris. If a blade binds in a cut, don’t try to get it out by applying “up and

down” force to pry the cut open. Applying prying force to the blade can bend

the blade, and result in blade failure and injury.

To free a blade that is bound in the cut, stop the engine, and support the

trimmer or brushcutter to keep stress off the blade. Push the tree away from

the entry point of the cut to open the cut, and pull the blade directly away

from the cut in a straight-line motion. Use caution when releasing the tree to

avoid being struck by spring-back or falling.

Inspect the blade for damage before proceeding. Sharpen teeth if dull, or

replace blade if cracked, bent, missing teeth, or otherwise damaged.

To prevent binding:

• Keep blades sharp

• Avoid excessive pressure during cuts

• Don’t exceed cutting capacity of blade

• Don’t use blades with damaged or missing cutting teeth

• Don’t rock blades in cut