Use and Care Manual

ASSEMBLY SRM-266

18 X7502028001

1. Be sure adapter plate (C)

remains on PTO shaft (A).

2. Align locking hole in upper plate

with notch in edge of gear

housing and insert head locking

tool (D).

3. Thread line head (E) onto shaft

by turning it counterclockwise

until head is tight against adapter

plate (C).

4. Remove locking tool (D).

Semi-automatic nylon line heads must be used only with debris shield

with cut-off knife. Using nylon line heads with debris shield without cutoff

knife can result in trimmer damage, caused by operation with excessive

line length.

Note: Your nylon line head may appear different than nylon line head

shown.

To Advance Trimmer Line

See Maintenance Section for nylon line replacement.

Note: To advance trimmer line, tap trimmer head against the ground

while the head is turning at normal operating speed.