Use and Care Manual

X7502028001 19

SRM-266 OPERATION

Remove Nylon Line Head

Note: Do not disassemble nylon

line head.

1. Align locking hole in upper plate

with notch in edge of gear

housing and insert head locking

tool (D).

2. Remove line head (E) by turning

it clockwise until head is

completely off of shaft.

3. Remove locking tool (D).

Support Handle Installation

Note: Label shows minimum

spacing for support

handle location.

1. If necessary, position support

handle for comfortable operation

and securely tighten screws.

OPERATION

Moving parts can amputate fingers or cause severe injuries. Keep

hands, clothing and loose objects away from all openings. Always

stop engine, disconnect spark plug, and make sure all moving

parts have come to a complete stop before removing obstructions,

clearing debris, or servicing unit.

Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a

poison gas. Breathing CO can cause unconsciousness, serious

injury, or death. Exhaust can cause serious burns. ALWAYS

position unit so that exhaust is directed away from your face and

body.

MINIMUM

SPACING