Use and Care Manual

OPERATION SRM-266

20 X7502028001

Operation of this equipment may create sparks that can start

fires around dry vegetation.This unit is equipped with a spark

arrestor to prevent discharge of hot particles from the

engine. Metal cutters can also create sparks if the cutter

strikes rocks, metal, or other hard objects. Contact local fire

authorities for laws or regulations regarding fire prevention

requirements

Operation With Blades

Blade use DEMANDS specific Brush Cutter configuration.

Operation without specified shield, barrier bar or U-handle, and

harness can result in serious personal injury. Follow installation

instructions.

DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL

TRIMMERS.

• Arbor Diameter of Upper Blade Plate must match arbor diameter of blades.

• New cotter pin required each time blade is installed.

• Brush cutters over 7.5 kg (16.5 lbs.) dry weight (weight w/o fuel) require a

double shoulder harness.

PARTS REQUIRED FOR THESE BLADES:

Pro Maxi-Cut Grass/

Weed Blade

Rigid Plastic Tri-Cut

Grass/Weed Blade

Metal Blade

Support Handle, w/ or

w/o Barrier Bar

U-Handle or Support

Handle w/Barrier Bar

U-Handle or Support

Handle w/Barrier Bar

Shield w/cutoff knife Shield w/cutoff knife Shield w/o cutoff knife

Harness Harness Harness

Upper Plate & Flat

Washer

Upper Plate & Glide

Cup

Upper/Lower Blade

Plates

Hex Nut Hex Nut Hex Nut

New Cotter Pin New Cotter Pin New Cotter Pin