Use and Care Manual

X7502028001 35

SRM-266 MAINTENANCE

Gear Housing

1. Clean all loose debris from gear

case.

2. Remove plug (A) and check

level of grease.

3. Add grease if necessary. DO

NOT over-fill.

Drive Shaft (flex cable models)

1. Loosen two (2) screws (B) and

remove center locating screw

(C). Pull gear case and shield

from drive shaft housing.

2. Pull flexible cable from the drive

shaft housing, wipe clean and

re-coat with a thin coating (15 ml

[1/2 oz.]) of grease.

3. Slide the flexible cable back in

the drive housing. DO NOT get

dirt on the flex cable.

4. Install the gear housing and shield assembly.

Flat edge of washers (D) must be against drive shaft.

Nylon Line Head Disassembly Instructions

Note: For normal use, Speed Feed® head disassembly is not

necessary. However, if circumstances require disassembly,

follow these instructions.

1. Press top of locking tabs (A) on

both sides of Speed Feed®

head to release cover (B) from

eyelet carrier (C).

2. Remove cover from eyelet

carrier.