Use and Care Manual

Grass Trimmer/Brush CuTTer

OperaTOr's manual

1. Cut one piece of line to recommended length.

.080 (2.0 mm) dia. – 20’ (6 m)

.095 (2.4 mm) dia. – 20’ (6 m)

nylon lIne replacement

2. Align arrows on top of knob with openings in eyelets.

3. Insert one end of trimmer line into an eyelet, and push line equal

distance through trimmer head.

4. Hold trimmer head while turning knob clockwise to wind line onto

spool until about 5” (13 cm) of each line remains exposed.

Trimmer head is now fully loaded and ready for operation.

Parts Required: Echo 2.4mm (0.095 in.) Nylon Line 6m (20 feet)

Wear Indicators

NOTE:

Trimmer head is pre-wound with .095" (2.4mm) Crossre™ trimmer

line.

IMPORTANT

When the wear indicators located at the bottom of the Speed-Feed

head are worn smooth, replacement of the cover or the entire

Speed-Feed

head is required.