Use and Care Manual

MAINTENANCE SRM-3020

38 X7502350000

Engine Break-In

New engines must be operated a minimum duration of two tanks of fuel

break-in before carburetor adjustments can be made. During the break-in

period your engine performance will increase and exhaust emissions will

stabilize. Idle speed can be adjusted as required.

High Altitude Operation

This engine has been factory adjusted to maintain satisfactory starting, and

durability performance up to 330 m (1100 ft.) above sea level (ASL) (96.0

kPa). To maintain proper engine operation above 330 m (1100 ft.) ASL the

carburetor may

need to be adjusted by an authorized service dealer.

If the engine is adjusted for operation above 330 m (1100 ft.) ASL, the

carburetor must be re-adjusted when operating the engine below

330 m (1100 ft.) ASL, otherwise severe engine damage may result.

Note: Every unit is run at the

factory and the carburetor

is set in compliance with

emission regulations.

Carburetor adjustments,

other than idle speed,

must be performed by an

authorized dealer.

1. Check idle speed and reset if

necessary. If a tachometer is

available, idle speed screw (A)

should be set to the

specifications found on

“Specifications” page of this

manual. Turn idle screw (A)

clockwise to increase idle speed; counterclockwise to decrease idle

speed.

Lubrication

Level 1.

Parts Required: Lithium Based Grease.