Use and Care Manual

MAINTENANCE SRM-3020U

42 X7502350201

5. Remove grass and leaves from

the grid (C) between the recoil

starter and fuel tank.

6. Assemble components in

reverse order.

Exhaust System

Spark Arrestor Screen

Level 2.

Parts Required: Spark Arrestor Screen, Gasket>

1. Remove spark plug lead.

2. Remove muffler cover (A).

3. Place piston at Top Dead

Center (TDC) to prevent carbon

or dirt from entering cylinder.

4. Remove spark arrestor screen

cover (B), gasket (C), and

screen (D), from muffler body.

5. Clean carbon deposits from

muffler components.

Note: When cleaning carbon

deposit, be careful not to

damage the catalytic

element inside muffler.

6. Replace screen if it is cracked, plugged, or has holes burned through.

7. Assemble components in reverse order.

Exhaust Port Cleaning

Level 2.

1. Remove spark plug lead from spark plug, and remove muffler cover.

Parts Required: As needed: Heat Shield